Reviews: KC HiLites SlimLite Fog Lights

Easy, plugs in to factory fog light plug. Done in a flash

I needed to replace my LJ's stock fog lights. I wanted to go 100 watts, but the stock wiring can only handle 55 watts.These installed easily since they plug into the factory wiring harness. I like the plastic lens covers.

These work great on my Jeep. Much brighter lights than the factory ones. I did drill out the factory light's rear square alignment hole to move the lights behind the bumper.

A car wash snapped the bracket to one of my fog lights and these factory replacements were perfect. They require you to drill out the mounting hole slightly, but this easy task is the "hardest" part of mounting these easy lights. They look great!

Great replacement fog lamp and also comes with rock guards. Unplug your old ones and plug in the new ones..it's that simple. The mounting bolt is a little bit larger than the factory hole, you will need to drill it out a little bit before installation

I used my KC Hilites on the front of my Jeep Wrangler TJ , and looking Cool !!!

Unplug the old one, open up the mounting hole, mount and plug in to factory plug. Easy day. Should buy two because it looks significantly different when it's beside the original factory unit on the bumper. Other than that, it's a great light.

These lights are plug & play as the wiring directly connects to the OEM harness on my 2006 Rubicon. They work great on the street & trail as the wide dispersed light fills in the dark areas on each side that the headlights don't cover. I would have given the product five-stars but I'm skeptical that the plastic mounting brackets will not hold up to heavy use. Time will tell.

They could have implemented a better way to adjust and secure the lights vertical and horizontal direction. I also had to flip the brackets around so the lights weren't sticking out so far in front of the bumper. it looked kinda funny, and were more susceptible to damage. Fit and finish were excellent. Overall, a very good product.

This was a really good purchase. If you want to use OEM fog switch you need to do some reaserch online to figure out how. You can also use the switch they give you if you do not mind installing switches all over your vehicle. I mounted these on my roller fairlead, they mounted easily, with some reaserch online, the install was a snap.

they install easily, they look good, they're bright, they light the sides of the road / trail well, they are too bright for street use when other vehicles are around, the tabs on the brackets don't hold the bolt head in place when the bolt is tightened

After figuring out how to wire them to the factory fog lite wiring, then they were easy to install. Look great.