When you're ready to put some new nerf bars on your off-roading 4x4, you can look to us for the step bar mount kit you need. Certain brands or styles require you purchase the mounting brackets for your side step bars separately, and typically these styles are a bit cheaper. Whether you need an extra mounting bracket or a replacement, you can find style you need for your truck steps or Jeep running boards here, at 4 Wheel Parts.

Easy Installation

1. Read through the instruction manual carefully to ensure any specific variations are followed. Failure to adhere to the correct procedure often voids the warranty.
2. You should have the nerf bars, two brackets for each bar and two bolts per bracket. The smaller bracket is intended for the front of the vehicle, and the larger one for the back.
3. Use the appropriate-sized socket (typically around 19-21 mm) for your vehicle and a long breaker bar or ratchet to remove the bolt on the front mount. Hang onto the circular bushing the bolt was holding in place to use between the vehicle and the bracket.
4. Place the hole in the bushing against the top hole in the smaller bracket and push the new bolt through the two, screwing it into the front mount by hand, to make adjusting easier later.
5. Repeat the same process on the back mount, and make sure the hole on the front of each bracket is facing the outside of the vehicle.
6. Next, you will take the nerf step and line it up to the proper sides, matching up the holes to the those in the front of the brackets, and tightening the bolts in by hand. You may want a companion to help hold up the nerf bar to line correctly.
7. Once you have it all in place, you can use a level to make sure that everything has been installed correctly, and adjust as needed before properly tightening all bolts.