Reviews: Daystar Bump Stops

This is an awesome product. I needed extended bump stops and the steel cups that hold them to My TJ Wrangler frame were rotted. These thread right in the spring tower where the cup bolts on replacing both. Saved Me $100

Great product that is much easier to install than the other kind you have to pound into the bump stop cup! Glad to have found these.

I needed new bump stops on a 99 TJ. Stock ones were worn out and since I was installing a 2" lift I thought it was a good time to replace them. They bolted right up with no problems and I'm using them at the full lenght on the rear (5") and I cut 2 inches off the fronts. Rides great ! This isn't my off road rig. Daily driver with occasional dirt roads/hills

Finally found bump stops that fit my 1985 Dodge W350. Thanks to 4 Wheel Parts, they took the time to measure their Bump Stops until they found one that would fit. Glenn

Perfect for a 1st gen ifs 4runner if your torsion bars are cranked up.

I installed these on my 2000 Tj. I removed the rear tires, one end of the trackbar, bottom shock bolts and lifted my jeep up from the rear bumper to remove the coil springs. You might also need to remove the back end of your rear drive shaft for more flex and mabye one end of your control arms.To remove the stock bump stop just wrap your hands around it and work it back and forth while pulling down and it comes out, its pressed in. Remove the bolt that is in the center of the cup. I put a light coat of lube on the new bump stop around the top edge to make it easier to install and get the bolt started in the threads. I then used a pipe wrench on the metal part to get it snug.

Great product and great price. Would buy again.

Really simple install. Stock bump stops were trash after 10 yrs.