Reviews: Smittybilt Standard Bucket Front Seat (Black Vinyl) - 44901

I have a 1984 CJ7 and these seats bolt right in. Really like the seat. I have a question as to what is the part number for the rear seat? I was not able to find the match?

I ordered a pair of these Smittybilt seats for my 1967 Nissan Patrol to replace the horrible original seats with something more comfortable. These were exactly what I needed. They are very comfortable and do the job well. Please note that the backs are fixed and cannot adjust in any way. Not a problem for me, but just so you know. Also the height is not a full headrest height, but more of a mid height headrest. Quality is great for just over a hundred bucks each.

Easy to install. Very comfortable. Fast shipping.

Great value! These are nice seats.

Nice looking and fitting seats. They were a great improvement in my old Jeep.

I put these in an old vw beetle. a trip to the local hardware and about $10.00 and they were installed on the factory seat frames so they will fully adjust and are a lot better than the old vw seats.

great seat to get, i would buy it again.

THis is a second purchase for these items. Also had them in an 83 CJ7. Loved them then and love them now in my 73 Commando. Makes a clean and factory look while updating the comfort level.

I put these seats in my CJ7 (Seven of Mine) WOW!! They fit great, they look great, they sit great, price was great, and you can't go wrong with Smittybilt. They know JEEP parts, they are JEEP people. Was missing 1 bolt, just ran down to the hardware store and BAM done. I'm sure they would have sent me the bolt I was missing, but I was ready to go JEEPIN!!!

Seats are perfect with the exception of the openings on each side of the seat where the back bolts to the seat. The openings collect and hold a good little bit of water, I use neoprene seat covers anyway though.

Awesome seats. Comfortable & look great!

It is a comfortable seat. And looks good too. I think if you buy them at 4WP they should install them for free, or perhaps at a lower cost. They get you on the installation.

Replaced both seats in a 1989 Wrangler yj. These seats fit well and they have 8 mm nuts so you may need to pick up a few new 8 mm bolts as my old ones were not the right threads. These seats have a thick padded seat so they make you set up a little higher than the OEM seats. They do not tilt or recline but seem to be leaned back just a bit too far which makes it a little uncomfortable to my taste. Otherwise they seem to be well built and look good in the jeep.