Reviews: Smittybilt Receiver Hitches

Fit perfectly. Just what I needed to carry hitch mounted accessories!

This hitch was easy to install. I did not remove hook or exhaust. I just removed bumper cover. It can go on in under a hour. I torqued bolts to 60lbs. Its perfect!

Easy install. Sturdy with no fuss receiver. Hardware was included.

Heavy Duty...check Wiring Harness....check Relatively easy install....check this was exactly as described. Haven't towed with it yet, but i expect it to do just fine.

Easy to install. I did have to loosen up the rear bumper in order to get the washers and nuts on but it was easy. Took 30 mins. I even bought the Smittybilt trailer harness and it was a breeze. I highly recommend these products.

I did not remove my bumper as some others have. I would not remove the bumper. An open end wrench and some tape are all you need for a 15 minute installation. Do not tighten the bolts all the way until all of the long bolts are in the hitch. The bolts will go in with the muffler in place with just a little wiggling. I installed the outside two bolts first and needed to loosen them to get the middle ones in. A headlamp will help since everything is black like a cave. when you are looking up at it.

After reading all of the reviews I decided to purchase this hitch. I removed the bumper like others said they did to install the hitch and it was well worth the time. I also purchased the factory plug and play trailer harness and it fit perfect on the hitch.

4wheel parts is a awesome company with great products and I will continue to purchase from them

Cargo holder for stuff you don't want inside.

Fits my 2013 Wrangler JK snug and looks like factory install.

This thing went on very easy--put it on (12-14-2012) Took about 35 minutes to install on a 2008 Jeep wrangler. Haven't used it yet--but the welds look pretty good--so don't think there will be a problem.

I took off the bumper skin and bolted the receiver to the bumper in an easy 15 minutes. I needed it to pull my boat while waiting for my custom bumpers to be delivered. Don't hesitate to get one of these as the fit and finish are excellent.

Great product for a great price. It was really easy to install and I installed the trailer wiring harness at the same time in under one hour.

This was pretty easy, less than 45 minutes total for the installation. Hints: There is little space between the bumper and frame. I used a piece of 1x3 as a wedge which helped a lot. I used contact cement to glue the nuts and washers together. I installed a harness too... The instructions said to drill a hole for the ground lug, but I found that there were some threaded studs already in place... I think I used a 6.5mm nut (from the junk pile)

the only thing i did not like is the hardware that came with the hitch. it comes with metric 8.8 grade bolts, i would rather it come with 10.9 grade. i used 4 1?2 inch grade 8 bolts with flange lock nuts. this really wasn't much of a con. overall great product for those that don't have a hitch.