Reviews: Rugged Ridge Fog Light Euro Guards

Instructions suggest to remove the plastic underbelly to access the fog lights. Remove 4 screws from each fog light ( the driver's side is extremely difficult to get to the 2 outside screws due to obstructions in the way). Once the fog light is removed, place the euro guard in to the opening, replace the fog light and install 4 screws. Pretty simple right? However, after over an hour of trying to get the fog lights back in, I realized that if you have a special model JK with a colored bumper cover over the center section (Altitude, or in my case a Black Bear Edition) they will not fit without removing the center cover first. I removed the center bumper cover, and then the fog lights fit back into place with the guards over them. I re-installed the fogs then had to re-install the center bumper cover. My advice, install the center bumper cover by first putting in the 4 screws underneath finger-tight, then really stretch it over the top so that you can get the remaining 4 screws in. Tighten everything back up and you'll be good to go.