Reviews: GraBarsUSA GraBars

Great product easy install quick shipment from you

Recommend GraBars! There is a difference between these and the Knock-offs!

Very strong and solid handles. Fairly easy to install. Would have been easier if I hadn't put my hardtop on the day before. Bolts right into upper windshield/rollbar. Just remove/reinsert rollbar screws. I had to also loosen a piece of side trim but it all went back together fine. ZERO wiggle or flex. Feels very solid. Don't know how much I'll use them with the doors on, but the other 8 months w/o doors they will be great. They have a good look to them as well. I have an '01 TJ Wrangler. (I think install on a little later TJ's is slightly different)

Installed on my 2002 TJ. Easy install, hint remove one bolt at a time, inside one first so rollbar stays lined up with windshield, then start bolt through grabar, remove second bolt (outside one) swing grabar to line up and start outside bolt. These appear to be very stout and good quality, not like that cheap Chinese ones selling in eBay for less than half price. I don?t think you?ll be disappointed with purchase. I?m satisfied and would buy again.

Quick and straightforward installation which took about 25 minutes for all four grabars. They are rock solid and well worth the cost. This is a much better and more stable way to get into and out of my jeep.

Installed these on my 89 Jeep YJ. Very easy. It took 10 minutes to do both sides. The factory Torx bolts were too short. I used longer hex bolts and washers. These are solid. They make it easier to get in and out of the Jeep. Much better than the strap handles that wrap around the roll bar.

I don't know what the other reviewer was talking about but there was no custom cutting involved to get these things to fit. I just got mine yesterday and installed them. It did take a little bit longer than I anticipated to get them installed because I didn't have the needed tools but after an hour everything was installed just fine and I didn't do anything special. they fit perfectly into the existing bolt holes with no cutting. And I'm already getting compliments on how nice they look.

This product is awesome! Very detailed and helpful installation instructions. These grab bars are the best on the market for entry and exit to a Jeep JK.

These are great looking and feel solid when you grab on to get in and out of my jeep

They arrived a day early which as great. Being made out of 3/4" steel they are beefy, 11 lbs to be exact. We ordered 2 sets, Red for my Anvil color JK and Black for her Black JK. The rear set were super easy to install. The front took a little more time. Do what the instructions say and clean as much of the Loctite out of the threads as you can. The pain of the front set is the mounting bolts don't go straight in. The top and side one have to go in with a little bit of angle so it took a little work to find that angle and then be sure there was no cross threading. Otherwise we love them and they are a great simple mod for function and looks.

Would give it 5 stars except that the holes and bolts didn't line up cleanly with the factory hardware holes for the front bars. I'm sure a slight tweak could fix the issue.