Reviews: G2 Chrysler 9.25 Inch Rear 4.10 Ratio Ring and Pinion - 2-2028-410

I installed these in my 94 1500 and noticed a big difference in the off idle power. I went from the stock 3:55's to a set of these and the engine no longer shifts all over the place while driving around town or going up a hill. Fuel mileage is about the same. I'll be using G2's in the future again. Don't forget if you change your ratio from the stock setup it'll throw off your speedometer....

Mr. Sings-like-a-canary probably needs to check pre-load on the pinion shaft, spacing & gear-lash(w/shim kit), and or fluid(s) for starters. Recommend using a Master Install kit w/instructions, and using ALL required torque wrenches and gauges.

Needed an upgrade from my stock 3.55 to 4.10's as they were beginning to wear.