Reviews: Fab Fours Vengeance Rear Bumpers

Looks good, fits a Tacoma well, and easy to install with minimal skills needed.

Shipping packaging was great well protected. It fit perfectly and the powered coat was prefect.

Easy installation, looks great! Came very well packaged.

Just installed this bumper on my ‘19 Power Wagon. I’ve got a couple very minor things that could be addressed to make instal better. First, taking the time to carefully remove all the plastic mounting points for the oem harness to the oem bumper was a waste of time as the Vengeance Bumper didn’t have mount points to press them back into. Could’ve just cut the ties and saved me some time. Second there are 6 holes cut for sensors and the ‘19 Wagon only has 4 sensors. For some reason they didn’t put the mount brackets on the two. Enter holes like are on the other for holes including the two that aren’t used so you have to carefully peel off the center sensor brackets and epoxy them to the bumper. Now of course due to my inexperience with the epoxy, some seeped out of the sensor and looks cheesy. Hopefully an exacto nice will clean it up. The outer most holes that are actually on the box side are just empty open holes. Might try to find a small diameter led amber light and wire into the turn signals. The remote sensor is a pain in the ass as you have to mount it to the license frame attached to the trailer hitch and then try to connect the terminal while holding the bumper close to it without scratching the bed sides. Highly recommend putting tape on the box side to prevent damage as it fits up snug and that makes it look nice. Well done on the measurements. Tucked up. Nice and tight once installed completely. If they could find a way/place to mount the remote sensor to the bumper like oem it would be very helpful. Also, Inhave the bed access step on my truck and could have used 1/4 longer bolts for the two on the drivers side. I made the bolts work but was not able to use both the locking and flat washer in the. It side. Lastly and least important is the led light strip supplied to light up the logo has two short of leads to really do much with. So I didn’t install it. I may try to build a wire harness to incorporate the above mentioned led “marker” lights if I can find them and also two sets of 3x3 pods and the led logo light. I’d have given it a 5 star if not for the extra sensor holes.