TeraFlex Falcon Series Shocks

From $1,705.99

• JK specific reservior locations
• Increases vehicle stability
• Improved dynamic roll control
• Optimized fitment for clearance during full suspension travel and articulation
• Front offset stud design creates additional frame clearance
• Piggyback design increases fluid flow by 6x over restricting reservoir hose designs
• California Residents: WARNING

TeraFlex Leveling Kits

From $1,507.99

• .5" up to 2" options
• TeraFlex has the perfect solution to level your vehicle if it is dipping in the front from the weight of a winch, sagging, or to level out a loaded vehicle
• These spacers are designed to work in stock configuration, or with a lifted vehicle
• All spacers are sold individually
• California Residents: WARNING

TeraFlex Flex Control Arms

From $1,239.99

• FlexArms allow custom pinion and caster angles to be set for proper alignment, they also are used to re-center the axle in the wheel well for proper suspension movement, and to adjust wheelbase length
• California Residents: WARNING

TeraFlex Steering Stabilizer Kits

From $301.99

• Mounting Brackets
• Hardware Kit
• California Residents: WARNING

TeraFlex Swaybar Quick Disconnects

From $12.99

• TeraFlex Quick Disconnects are the leader in the industry
• The sway bar link uses a large polyurethane ball and pin for easy sway bar link removal
• When connected for street use the link provides immediate reaction during sway bar loading to eliminate excess play
• California Residents: WARNING

Cognito Motorsports Replacement Suspension

From $2,562.30

• This kit is designed with both recreation and competition in mind
• The suspension gives you a wider stance for stability and extra travel which is a must have for duners and desert racers
• The weight conscious Chromoly and DOM construction gives this suspension necessary strength while staying light weight
• California Residents: WARNING

Cognito Motorsports Radius Rods

From $209.59

TeraFlex CRD60 HD Axle Assemblies

From $2,974.99

• Tera CRD60 specific high-pinion rear axle housing design
• HD bearing caps increase rigidity and reduce ring and pinion distortion
• Constant Radius Design (CRD) provides maximum ground clearance regardless of pinion angle
• Built-in “skimmer” cuts ring gear oil halo and forces it into the pinion bearings
• Outer pinion bearing pocket features a renewable oil reservoir that sends cool oil to the pinion bearing
• Oversized outer pinion bearing handles increased torque and high-load conditions
• High-capacity housing holds maximum amount of oil
• Asymmetric housing design for extra-long tube side strength
• Pre-installed inner axle seals
• Ductile cast iron housing with increased rib gussets
• HD ductile iron differential cover with increased cover mounting area
• Integrated lower control arm skid plates
• High-flow oil passages
• Bottom oil drain hole for simple fluid changes
• Reinforced rear track bar mount with multiple mounting locations
• UV protected triple-stage powder coat for corrosion resistance
• 1/4”-thick CNC laser cut axle brackets for extreme strength
• Pre-installed upper control arm bushings
• Proper pinion angle for lifted applications
• Features a raised pinion angle and raised track bar bracket
• Pre-tapped hole on spring perch for bump stop extensions
• Pre-drilled holes for limit straps and lower spring retainers
• Retains all ESP, ABS, and speedometer sensor capability
• 100% engineered, designed, and built in the USA with new components

TeraFlex Extreme HD Drag Link Kit

From $15.99

• The TeraFlex HD drag link kit is designed for extreme conditions that typically will cause factory steering components to bend and fail
• California Residents: WARNING

TeraFlex High Steer System

From $1,097.99

• Includes tie rod/drag link with one ton tie rod ends
• Tapered inserts
• Pitman arm
• HD cast high steer knuckle
• For use with LCG Lift Kits
• California Residents: WARNING

TeraFlex Rzeppa Factory Replacement CV Kit

From $184.99

• TeraFlex has created the High Angle Rzeppa Factory Replacement CV Joint Kit to help you retain your driveline
• With the High Angle CV housing, it can decrease the boot failure that's commonly seen in taller lifts
• Included in the kit are socket head bolts, the CV joint assembly, a 6 mm Allen wrench, the high angle CV housing boot and the cap, the bolt flanges, and low friction CV grease
• California Residents: WARNING

TeraFlex Skid Plates

From $11.99

• Jeep skid plates designed to increase overall ground clearance by replacing factory skid plate
• Manufactuered with Stronger and Heavier 1/4" guaged materials
• Installation hardware included
• California Residents: WARNING

TeraFlex NP231 Extreme Short Shaft Kit

From $399.99

• Extreme Short Shaft Kit
• With 231 transfer case
• Eliminates slip yoke
• Requires a longer CV style drive shaft
• California Residents: WARNING

Cognito Motorsports Axle Shafts

From $259.99

• Heavy Duty construction
• Summers Brothers 300M forged steel axles are stronger than stock while still retaining the same spline as OEM
• California Residents: WARNING

TeraFlex Differential Covers

From $115.99

• Designed to offer extreme protection from rocks, obstacles and other debris on the trail
• Covers are cast from the same high-strength ductile-iron as our their axle housings
• Features a large diameter fill tube/inspection port at the top to accommodate a funnel or gear oil bottle pour spout
• Fluid level port doubles as a mid-height inspection port
• California Residents: WARNING

TeraFlex CB Antenna Mounts

From $28.99

• Black
• Easily mount a CB antenna
• Positions the antenna behind the spare tire and in some cases flexibility of the antenna will be limited
• Includes mounting hardware
• California Residents: WARNING

TeraFlex Trackbar Kits

From $278.99

• Adjustable Track Bar
• Frame Side Bracket
• Axle Side Bracket
• Use With High Steer Knuckle
• California Residents: WARNING

TeraFlex Ball Joints

From $155.99

• 1045 carbon steel housing with magnesium phosphate coated assembly
• 4140 chromoly ball/stud with magnesium phosphate anti-corrosion coating
• Factory style serrated flanged castle nut
• CR black neoprene boot
• California Residents: WARNING

TeraFlex Coil Springs

From $245.99

• Coil Springs
• Linear design with Extensive rate tuning and dynamic balance
• Deliver unsurpassed highway handling and off road performance
• Shot peened to reduce spring sag and fatigue
• Powdercoated for superior element protection
• Limited lifetime warranty against defects
• California Residents: WARNING

TeraFlex Single Rate S/T Sway Bar Systems

From $793.99

• Forged street front sway bar
• All necessary hardware
• And more
• California Residents: WARNING

TeraFlex Sway Bar Links

From $16.99

• Sway Bar Links
• Teraflex Front Links when connected provides immediate reaction during sway bar loading to eliminate excess play
• Rear Links are designed to reduce clearance issues between the tire and rear sway bar
• Available for different lift heights and fixed or quick disconnect styles
• California Residents: WARNING

Cognito Motorsports Tie Rod Kit

From $407.59

• Heavy Duty Chromoly construction
• No cutting or welding required
• This kit is designed with both recreation and competition in mind
• The Chromoly construction gives this kit high strength while staying light weight
• This kit also includes Chromoly heim joints at the spindle to increase strength and longevity
• California Residents: WARNING

TeraFlex Trackbar Brackets

From $105.99

• Front and rear applications
• Laser cut from 1/4? steel and accurately formed to ensure proper positioning for correct suspension geometry
• Track bar bracket restores the factory handling and correct roll center for a lifted vehicles
• Track bar brackets are recommended for superior drivability to reduce rear body roll tendencies by restoring the proper roll center of the vehicle
• Welding is recommended for final installation
• California Residents: WARNING

Cognito Motorsports UTV Cages

From $2,911.71

• 1-3/4 inch DOM tubing construction
• Bare steel
• Standard with predrilled inserts for Light Bar Mounting Kit
• Includes 2 whip mounts and rear view mirror
• No welding required
• California Residents: WARNING