The Universal Shock Hoop Kit is long enough to accommodate a 14? shock, but not so long that you cannot use a 12? shock. The shock hoops are made out of 1035 DOM and are precision CNC bent to ensure the highest quality product. From the top of the hoop to the bottom it measures 16?, and from the weldment mounting surface to the shock eye brackets measures 13?. Some modifications may be required during installation.
Trail-Gear introduces the industry's first 6-layer, 1.75 inch nylon webbing limit straps. Each strap features 4130 heat-treated Chromoly Steel buckles that have been zinc-plated for corrosion-resistance and mounting holes. These straps are made from 9,000 lb. test nylon straps and offer minimal stretch to protect against full extension and possible breakage of the shocks on even the most extreme terrain. Anti-abrasion clips have been installed in each buckle to minimize wear. Strap lengths are measured from the center of the mounting holes and are guaranteed accurate to +/-. When selecting, choose a limit strap that is 1 inch shorter than the shock to prevent full extension and possible breakage of shock. Sold individually.
Each kit contains two flip plates and four 9/16 inch bolts with nuts and washers. Front kits will accommodate spring packs up to 2 inch thick. Rear kits will accommodate spring packs up to 2.5 inch thick. Crossover steering required for installation of flip kit. Unpainted finish.
These shock mounts are designed to weld directly on to the axle housing. Can be used for front or rear axle applications. Made from 3/16 inch plate steel. Mounts have curved bottoms that can be mounted horizontally or vertically on axle. Mount is 2.5 inch tall with 1/2 inch shock mount holes.
This kit includes two large hoops that can be coped and welded onto a frame or an exo-cage and one 3' section of tubing that can be cut to size and welded between the two hoops. Once you have done this all that is left is to weld the shock mounts onto the tube in the desired location and you are done. All tubes in this kit are 1035 DOM. Parts are shipped unpainted.
Trail Gear's hydraulic steering ram mounting brackets have a 5/8in. bolt hole and are formed out of 3/16in. Steel. All Of Trail Gear's Hydro Assist Brackets are designed to fit a factory Toyota solid axle front housing or a Trail Gear Rock Assault axle housing and a 1.25in. tie rod.
Trail Gear Trail-Link Three 3-Link Parts Panhard Frame Bracket
Built out of 3/16 inch Plate Steel, the Trail-Gear Link Mounts are a perfect solution for upgrading the factory brakets. They also make it easy to swap suspension from leaf springs to a 3-Link or 4-Link system.
Trail Gear Trail-Link Three 3-Link Parts Panhard Tubing
This drag link is made from .250 inch wall DOM 1.25 inch tubing, precision tapped, and features a left side thread mark. Each rod is test fitted to ensure that rod ends thread in with correct fit. Powder coat black finish.