Trail Gear Lift Leaf Springs

A: This is for a pair of add-a-leafs

A: Yes to everything below , With any three inch lifted springs I would add the parts listed below to correctly lift the Suzuki off the ground . And with the leaf springs you will need to purchase bushings separately this uses a factory style bushing so Energy suspension bushings are a great choice as well OME bushing kits .

A: The foot pounds per inch is 405lbs this will help the load . Doubling up the add-a-leaf would make for a stiff ride and maybe too much pressure on the main leafs in the stock pack . Could lead to a failure with the stock spring pack .

A: This add a leaf will be 29.5 arched and 2.38 wide

A: No you do not. You can re-use your original U-bolts

A: Hello Kevin, the Trail Gear 3 Inch Lift Leaf Springs will be a great replacement for your bad springs. WE carry a variety of shocks for your vehicle but unfortunately do not have driveshafts. Thank you for your inquiry.

A: Phil- Thanks for the question. I would recommend that you replace both your rear springs. If one is broken then the other couldn't be far behind it. The SS34r is discontinued and we no longer have any information on that part number.

A: Tiff- Thanks for your question. The Trail Gear 3 Inch Lift Leaf Springs are rear only.

A: Poor- Thank you for your question. The bushing for the Trail Gear 3 Inch Lift Leaf Springs can be found here http://jo.my/nwzzlx . Your stock u bolts should be able to be reused.

A: Hello Jake, Thank you for the question. You can run this in a SPOA or Spring Over Axle application. Please note this spring is a 3" lift so you will need longer shocks and driveshafts.