Ten Factory Dana 30/44 Red Outer Axle Tube Seals (Red) - MG21102

universal fit logo


  • Ten Factory | Part Number: MIDMG21102
  • Axle Location:Front
  • Axle Type:Dana 30 Reverse|Dana 44|Dana 30 TJ
  • Color:Red
  • Fitment:Universal Fit


These TEN Factory Axle Tube Seals are a new updated design of a product that helps to keep mud and debris out of your front model 30/44 axle tubes, these TEN Factory Axle Tube Seals are available in Black, Red and Silver. Will Not Work With Passenger Side Vacuum Disconnect Two Piece Axle Shaft

Customer Reviews

4.6 4.6
5 Customer ratings
5.0 Outer Axle Tube seals

Great product. Buyer beware, make sure you shop other vendors-4 Wheel parts had them listed at $88 while Amazon was listed at $28

from L A Area |
5.0 Nice addition to an axle.

These are a nice addition to your front axle. Great beefy look, fills the gap between the axle and the housing. Well constructed and fit perfectly. Seem to work well.

from Portland, OR |
3.0 What year 44???

Not sure what year it works on but it WILL NOT fit the HP Dana 44 from the 78' 79' f250. I think it's probably for a lighter duty (1/2ton)44.

from Arizona |
5.0 these should be factory equipped.

i cant believe they are not factory installed.way better than plastic inserts from jeep

from saco maine |


Question & Answers

3 Answered questions

Q: Will this product work on early CJ-7 Dana 30 (Wide Track) differentials? If not, do you have a product that will ? Thank you. Mike. Answer this question

A: Hello Mike No there isn't enough clearance between the yoke and the housing end. They stick out of the housing just under an inch. Thanks

Answered by Rody on 09/07/2015

Q: Why will the not work with the vacuum disconnect? I have taken the disconnect shafts out and just done a long shaft. Will this work since i have done that? Answer this question

A: Hello Silvy, the Ten Factory Dana 30/44 Red Outer Axle Tube Seals will not fit with the disconnect because the axle diameter is too large for the tube seals. Thank you for your inquiry.

Answered by mikey on 08/17/2014

Q: I have an 04 TJ Rubicon with a four inch lift and 33's. It has stock axles and lockers.I'm hoping these tube seals fit the stock DANA 44 axle without any problems. Any info will help me make the right decision to buy this product. Answer this question

A: Glen- Thank you for your question. Yes the Ten Factory Dana 30/44 Red Outer Axle Tube Seals will fit your 04 Jeep wrangler TJ with the stock axle shafts.

Answered by Mike on 05/03/2014