Smittybilt SRC Oversized Tire Carrier Mounts

A: No it will not fit. This is a Jeep JK application.

A: Most likely not without a cutout in the rear bumper.

A: No it will not fit. This is a Jeep application.

A: Hello Mel The S/B2743 bolts into the existing holes from the factory tire carrier. Thank You for your question. Jon Snyder 4Wheelparts

A: Thanks for the inquiry alex, the Smittybilt Oversized Tire Carrier part # S/B2743 this will work for your vehicle.

A: Hello Wingman, Yes, the Smittybilt Oversized Tire Carrier S/B2743 will work with your tire and wheel specs. Thank you.

A: Hello Stucco Man, The Smittybilt Oversized Tire Carrier is a good solution for carrying a larger tire and wheel. thank you.

A: Thanks for the inquiry cea, the Smittybilt Oversized Tire Carrier part # S/B2743 this will hold up to a 37 inch tire.

A: Hello Lester13, the Smittybilt Oversized Tire Carrier part# S/B2743 is made from powder coated steel. Thank you for your inquiry.

A: Hello Ranger, Thank you for asking. Here are the instructions. You can also click on download instructions so that you can see images. Step 1: Remove your spare tire. Now take off your 3rd brake light from its housing by removing the four screws on the back of it. Follow the wiring and disconnect at plug. Set the light and screws to the side for use later. Step 2: Remove the factory tire carrier by removing the 8 bolts that secure it to the tail gate. Set bolts to the side for use later. Step 3: Place the tire that you are going to be using flat on the ground, with the outside of the tire facing down. Set your new tire carrier base on tire with the tube portion going through the center of the wheel. While pushing the tire carrier down (making it even the tire) lay the brake light bracket on the tire carrier between the two flanges. Put the light bracket so the top of it where the light lens will be placed is just above the tire. Align the bracket holes to the best hole locations on the tire carrier. Secure tightly using the two supplied pan head screws, lock washers and nuts. (Fig A) Step 4: Measure the distance form the bottom set of holes on the tailgate where the factory tire carrier was mounted on; to a point on your bumper that will be below the spare tire. Set your new tire carrier back on your spare tire like you had done in Step 3. Measure from the bottom of the tire upwards the same distance that you just measured. Find the holes on the tire carrier that are the lowest close to that measurement. (Commonly 31” and smaller tires will use the top set of holes, 35” tires will use the middle set of holes and 37” tires will use the bottom set of holes) Now mount your new tire carrier on the tailgate using 4 of the factory bolts you

A: Hello Ranger and thank you for your question! Smittybilt Oversized Tire Carrier can use 1/2" locking lug nuts to hold the wheel and tire on.

A: Hello Danny The Smittybilt Oversized Tire Carrier can be secured with a standard pad lock.

A: Hello Rob, the Smittybilt Oversized Tire Carrier Part# S/B2743 will help evenly distribute the weight of your spare tire across the Tailgate of the Jeep. This carrier will hold your 35" tire no problem. Thank you for your inquiry.

A: Hi Flipper The Smittybilt oversize tire carrier will retain the factory third brake light. Thank You

A: Kal- Thanks for the question. You can retain your stock bumper with the Smittybilt Oversized Tire Carrier.