The all new Intelligent Rack is one of the smartest products introduced to the trail. This system gives you a solid platform to mount just about anything you can think of to the back of your Jeep. The I-Rack comes with custom mounts for a Gerry Can and Trail or High Lift jack. The multi attachment points allow you the opportunity to run military bags, axes, picks and shovels or whatever else is needed for thr trail at the time. This is truly one of the smartest racks on the trail today! Works with any aftermarket tire carrier.
great rack but the wing nut bolts suck, you can never get them tight enough. i replaced the wing nuts with proper bolts with lock washers and it works great now, does not loosen after all day wheeling and easer to use now.
By Sargent rock from Abbotsford ,British Columbia
Works great. But the instructions that came with it were lousy. Online instructions were much better.
By JK from West MI from Grand Rapids, Michigan
DOesn't work with stock Rubicon Rims
Doesn't work with stock rubicon rims, so I had to send it back. sucks. But it was made with good thick metal
By Markvic from Kansas
Irack is the Best
The Irack allows me to have 1 Jerry Can, High life Jack, Ax, and Shovel. I sometimes change the irack to mount 2 Jerry cans and others things that you might want to carry. Many members on the offroad club that I received jioned are planning to buy the irack to.
By Marco in Miami MOC from Miami Florida
Works as advertised. It's heavy (especially when fully loaded) and I'd only recommend it on a true tire carrier. After a couple uses, it developed some rust spots in the jerry can mount. One of the wingnuts worked itself out (didn't threadlock it) after less than a hundred miles. Just replaced it with a standard bolt. Also, a bit of rubber padding between the mount and receiver helped to alleviate the some of the noises and vibration/shaking.
By Scott from San Diego
Very Handy System
This product works very well. The newer iRack has two wing nuts that secure it to the spare tire mount. The instructions should include "use the blue thread locker to hold in place." This item was originally desinged to be used with a 3/8 inch trailer pin. Too many so called "jeepers" that like to take there rides to the mall complained "it's too noisy". My advise to them, sell your Jeep and get an SUV. This is not an item that only looks cool, it is very useful at 11,000 feet on a real trail. Don't change it for them yuppies. Bring back the pin!
By American Ride from Colorado Springs, CO
Worked just like I planned!
This product is made out of heavy grade metal and came with all of the parts to install AND the parts to install a highlift jack and gas can which should be bought to complete the look of this accessory. After I put my jack and gas can on only compliments followed by fellow jeepers. Great product, will change the look of any plain rear end of any jeep!
By Jono from Canton, GA
More show than go. But still very cool.
LOOKS GREAT ON MY 78 CJ7 W/ GAS TANK AND TOW STRAP AND JACK. CAUTION ON ROUGH BUMPY TRAIL MAY CAUSE EXSESSIVE STRESS ON FACTORY TIRE RACK AND BACK OF JEEP. SHOULD BE FINE ON TJ,YJ, OR ANY BUMPER MOUNT AFTERMARKET HIGH DOLLAR SPARE TIRE RACK...
For 60 years Smittybilt has been fabricating aftermarket parts and today their products include Jeep tops, bumpers, lighting, winches and trail gear. Off-roaders count on the company's innovative parts like the original nerf bar side steps to equip their Jeeps for the trail and day-to-day driving. Pairing affordability without compromising quality is the hallmark of Smittybilt and the manufacturer's reputation carries over to products like its Overlander Series of tents, Adventure Boxes and SEMA award-winning magnetic trail skins for Jeeps. Smittybilt offers over 2,000 interior and exterior parts and accessories for 4x4s with multiple capabilities for jeepers of all levels. Shop Smittybilt Now