Skyjacker Spacer Leveling Kits produce optimum results for the amount of money spent. Designed for specific applications, these kits fit right and work good.These kits add 1 inch inch of lift to your vehicles struts or coil springs, eliminating the factory nose down rake and allowing for the use of larger wheels and tires. No cutting or welding is required and standard tools will get the job done.
Kit was easy to install. providing you have a lift and air tools, it took me 2 hours.
By Turbokyle from Syr ny
Getting bigger tires
By Drew from Maryland
nice 2" lift.
on front spacers could use studs welded toward top. and the rear spacers could use studs welded toward the bottom, instead of just bolts an washers, an nuts. pain in the butt trying to hold in place while trying to put bolts an washers an nuts on......
By Frank's Turtle from Parker, AZ.
The actual kit is very easy to install, the only time consuming part is getting the struts back into place after spacers are installed. no special tools needed other than a side grinder to trim factory studs down a bit
By joe-d from flotown
Great product. Makes truck handle so much better
By asoltess23 from Kentucky
I installed this on my 2010 Chevy Silverado. I had never installed a leveling kit before, so the first side took a little over an hour, and the second less than 20 minutes. It helps to have someone else helping you out. Once installed I noticed an immediate difference. After measuring, discovered I had gained the full 2 inches, which I didn't think would happen. A larger set of tires will definitely set your truck off. In the instructions it states to swap each side's struts for the other (driver to passenger, passenger to driver), but I didn't waste my time. I just turned them around. Otherwise, your studs won't match up to the original stud holes in the top of the struts. Also, when placing the block on the top of the strut, put the locking nut on first THEN grind the top of the stud off so it's even with the top of the block. Otherwise, you'll have to file your thread so the nut will fit. Instructions are easy to follow. If you're looking for a good leveling kit that's not expensive, and easy to install, this is the one I would recommend.
By DoubleK from Iowa
great product would buy again anytime
great product.i installed it on my 2009 sliverado z71 4x4.it really made my truck look alot better and got the full 2" lift out of it.easy to follow instucions.the only down side of it that i dont under stand is haven to put the driver side strut on the passenger side and vise versa.but all in all i really like the product.
By runingelk66 from monticello,ar
I would buy this product again
I did not need to disconnect the upper control arms as the instructions stated. I used a floor jack to just slightly compress the strut and was able to get it into position.
By Offroader from Townsend, WI
Better than expected
Truck looks much better, and for some reason the truck rides smoother and the rough roads don't seem to be as bad. The bumps are not absorbed by only the front end. The truck rides even better considering it is a 08 sierra 4x4 short bed regular cab.
By 08 sierra from Jamestown, Ky
Simple and is what I wanted
I bought the product for my 1995 tacoma after replacing the rear leaf springs. The new leafs provide much taller ride height than I had anticipated and the truck had a horrible stance. The kit was easy to instal and leveled out my truck perfectly.
Will this product interfere with the toyota safety sense pre-crash system? Will it accommodate the factory sway bars on the 2018 toyota tundra trd sport 5.7L 4wd?
Scott from rifle, Colorado on
Everything I read about the Toyota safety sense system from Toyota's website does say that lifted vehicles may experience issues. They have the word lift listed 13 times, but also refer to vehicles hauling a heavy load or trailer as well. So it is kind of difficult to say 100% one way or another.
As far as the sway bars all I know for sure is that Skyjacker lists this kit to fit a 2018 Tundra 4WD. Only exceptions was that it does not fit TRD PRO or Air ride trucks.
Hope this helps
If you have any further questions you can contact our customer service center @ 877-474-4821
Does this kit require any additional hardware such as shock extensions?
Les from on
Thanks for the inquiry Les, the Skyjacker 2.5 Inch Leveling Kit parts # SKYF52MS we do recommend shock extensions or new longer shocks.
Does this spacer fit a 2013 2wd ram 2500 crew cab?
justin from on
The SKYD25MS only fits the 4WD Ram2500. I would recommend a DAYKC09100BK
Daystar 2 inch lift kit. This is a front coil spring spacer kit that fits your Ram 2500 2WD if it was made before May of 2013. If it has a production date in May of 2013 or after then you need part number DAYKC09134BK. Wither either of these 2 inch lifts longer front shocks are needed. I would recommend 2 each of DAYKUO1003 for the older
production dated truck and DAYKU01023BK for the new production date. DAYKC09125BK comes with the front lift and front and rear shocks for the older production date. DAYKC09137BK comes with the front lift and the front 2 shocks for newer production dated truck. Thank You for your question.
When it comes to leveling kits, suspension kits and sport lifts, Skyjacker Suspensions delivers a vast selection of parts for Jeeps. We carry everything from the basics to the odds and ends that keep rides smooth and bouncing in check on or off the trail. Wrangler, Cherokee, Rubicon drivers and more depend on the heavy-duty construction that has become a Skyjacker staple to make wheeling on big tires safe and sound. Everyone needs adventures in their life and Skyjacker products like suspension and stabilizer kits, shocks and coil springs help make them possible. Shop Skyjacker Now