Rancho Adjustable Control Arms

A: Upper Ball Joint (pre-installed) is the Moog Front Upper Ball Joint - Part Number: K80811

A: Thank you for the question. The Rancho RS64302 is designed for 3.5 - inch lift maximum.

A: Upper control arms do no provide lift, only helps with alignment.

A: Technically the OE upper control arm is already positioned correctly on Caster for this leveled vehicle from the factory. Rancho doesn’t recommend the upper control arms to replace OE non-lifted, leveled vehicles due to ball joint position. That all said, I would not qualify it.

A: If you are referring to brake hoses it appears there's a threaded stud on the arm to mount the brake hose bracket. For ABS/speed sensor wires people typically use zip ties if there is no place to mount the factory clip.

A: Yes it will help the angle and move caster back toward OE dimensions.

A: If its on the site we can order it.

A: RS64302 is just the control arms for the 20-19 GMC 1500. The complete 3” kit is RS66311R9, but it re-uses the factory coil spring and upper spring mount from the OE unit to be assembled. The leveling kit is RS66310R9 and it also uses the factory coil and top mount.

A: They might give too much caster if the 6” kit was designed with a knuckles to move everything to the OE position. These are truly made for the level/lift market where the factory arm and ball joint is in a lower position from the OE location due to the raising of the strut. They are not made as an OE replacement to a stock upper arm at standard height and normal control arm operation range.

A: We do not have it in stock but the vendor does and that is who would ship it to you.