A: Yes

A: On my 86 4runner, my rear leafs were sagging very badly. I added these and it raised the rear as well as stiffening the rear leafs. Quality of Ride was not affected, actually improved my ride. I would buy these again.

A: Yes I think you bought an extra set. I only put one leaf on each side, lifted my rear end 2.5 inches. Took that sag out of my 99 Jeep cherokee.

A: Yes, purchased one too many…The 13120 is a pair of add-a-leafs….one pair is required for a vehicle.

A: The Pro Comp Rear Add-A-Leaf Set - 13120 (2.25” wide)

A: Hello The EXP 13122 is the set for the full size trucks and suv's and comes as a pair. http://www.4wheelparts.com/Suspension/Rear-Add-A-Leaf-Kit-Pair.aspx?t_c=1&t_s=101&t_pt=5488&t_pn=EXP13122 Thanks

A: Hello Speadyk, This is for one add-a-leaf. You will need to purchase two for complete the rear of the vehicle. Thank you.

A: Thanks for the inquiry crazydriver, the Pro Comp Suspension Rear Add-A-Leaf Kit part # EXP13120 this will fit your 2015 Tacoma.

A: Thanks for the inquiry Brendan,the Pro Comp Suspension Rear Add-A-Leaf Kit part # EXP13120 this will work for your vehicle.

A: Thanks for the inquiry ryan, the Pro Comp Suspension Rear Add-A-Leaf Kit part # EXP13120 this is incorrect you'll need part # EXP51099B-5.

A: Hello I have checked and there is not a add-a-leaf listed that is narrow enough listed anymore. We did use the early CJ5 front add-a-leaf in the past but I don't see anyone that still offers it. The front springs are the same as the early CJ5 75 and older.

A: Dave,Thanks for the question.Part #EXP13120 flat length of this add-a-leaf is 21.50"

A: Hello big hauss, The Pro Comp Single Rear Add-A-Leaf Part Number: EXP13120 doesn not come with center pins. They are sold single. Thank you.

A: 80%- Thanks for your question. I generally recommend the long leaf as is the most effective in providing lift and stresses the stock leaf pack the least.

A: Canaan- Thanks for your question. The 32" Tires will need at least 4 inches of lift on your '82 toyota SR5 pickup. I would recommend the pro comp lift kit that included shocks and all 4 springs, part number EXPK5062B

A: Hello Walker, Thank you for the question. You will install the clamps in the factory locations (same location as factory leaf springs). When you have the clamps installed correctly you will not have any leaf spring noise.

A: Chrisd- Thank you for your question. You should install the Pro Comp Suspension Rear Add-A-Leaf Kit below the main pack but above the overload spring.

A: Hello Andrew, Thank you for the question. The Pro Comp Suspension Rear Add-A-Leaf Kit EXP13120 are sold individually