Pro Comp's Motorsports Series high intensity LED light bars set the standard in lighting efficiency. All Pro Comp LED light bars feature a 50,000 + hour life span, ultra-high lumens/watt, in a Patented Design One Piece Heatsink No Screw Design IP68 housing. The innovative design provides increased visibility in even the darkest of driving conditions. Installation is easy, and every light comes with everything you need to get your light installed and wired: wiring harness, switch, relay, mounting brackets and hardware. Whether you are close to home, or far off the beaten path, count on Pro Comp to light the way!
When you tighten down the bolt and nylon nut make certain that’s where you want it the nut is almost impossible to back off after tightening
By Dave c
from Northridge California
Great quality light, good bang for the buck. It came with good quality installation hardware and the best switch/harness I’ve seen with a set of lights.
5.0Pro Comp 20” double row LED light bar.
Works great - the light is very bright. Combo spot/flood is nice. Don’t forget to buy brackets (separate) to mount on hood of a Jeep.
from Savannah, GA
The led bar is good. The wiring harness on the other hand it lasted all of one ride and the relay and wires were all burn up. It’s says lifetime warranty but don’t fall for that. They replace it once and after that you’re done.
from Little Rock
5.0Pro Comp light bar
Very bright lights, easy install. The only difficulty was getting the wires through the firewall on my 2015 Silverado.
No. Also don’t mess with anything once it breaks just take it up there. I opened up the box that controls the pro comp lights to see if maybe it had water in it. Bad idea that voided the warranty because I opened it.
from Little Rock
Yes it does.
from 4WP Corporate Headquarters
I would like to mount this bar light on top of my brush guard in front of my grill. It has two metal tabs already in place and the holes are 16 inch from center to center. Will this light mount in this place?
Answer this question
Unfortunately this light bar mount is 20 1/2" may have to fabricate something. Or you might consider something like Part Number: BAJ557803
Pro Comp Suspension has spent the last two-and-a-half decades engineering, testing and manufacturing products that will give Jeep drivers the confidence to dominate whatever terrain is ahead. The Pro Comp Promise Life Time Warranty is forever. Pro Comp's warranty goes with the suspension products on Jeeps whether or not the Jeep owner is the person who originally purchased the product. Pro Comp Suspension can afford to give such a warranty because the products are produced at the Pro Comp facility in San Diego, California under exacting manufacturing standards. Pro Comp Suspension is the only suspension company with products that are tested under true driving conditions on outside roads, rather than simulated testing. Shop Pro Comp Suspension Now