A: I bought 6 degree aluminum shims which are thicker than the steel shims I've used in the past and shaved them down on a grinder. They are very close to 7 now.

A: The tallest 2” leaf degree shim that 4WP carries is 6 degree. Warrior Products PN 800052.

A: These are case aluminum and they are 2" wide.

A: Cast aluminum

A: if you look through the website they are available from 2-6 degrees, just order the ones you need

A: What vehicle are you working on? Please call our sales team with this info so we can get your the correct shims Toll Free: 1-877-474-4821

A: 5" long

A: You will need to look at the top of the center pin to see if there is .5-.75 thread sticking out past the nut. If so, the original center pin could be used. If pin is not long enough or if has become stretched, you will need to replace. You will to measure and order the correct diameter center pin.

A: 2.5"

A: The Pro Comp Degree Shim - 90103 dimensions are 1” x 3” x 6”.

A: Not enough to notice a difference.

A: 2.5" wide. Please use part number EXP99-400B

A: Greg, the Pro Comp Suspension Degree Shim is made from steel. Hope this helps!

A: Hello Mark, The Pro Comp Suspension Degree Shim are made of aluminum. Thanks for your question.

A: Hi Kevin The Degree Shim is made of aluminum. Thanks

A: Hello Rick, These Pro comp Suspension Degree Shims only come in a 2 1/2 wide and a max degree of 6. If you have anymore questions feel free to ask, Thank you.

A: Thanks for the inquiry cstevens21, the Pro Comp Suspension Degree Shim part # EXP99-200 is a single shim 5x2.

A: Hello Robert, Thank you for asking. Here are some 2.5" wide shims http://jo.my/ca12ly

A: Hello, These are 2.5 inches wide to match the springs. If you have anymore questions feel free to ask, Thank you.

A: Hello matt and thank you for your question! Pro Comp Suspension Degree Shim part number EXP99-250B is a 2.5 degree shim for a 3" wide leaf spring.

A: Hello Scott, the Pro Comp Suspension Degree Shim part# EXP99-250B are built for 2.5" wide leaf springs. Thank you for your inquiry.

A: Scott Thank you for asking. Pro Comp Suspension Degree Shim part# EXP 99-250b is for 3 inch wide springs.Part # R/ERE1464 is 2 degree & 2.5 wide.

A: Hello MudUp55, Thank you for the question. The Pro Comp Suspension Degree Shim are 2.5" wide.

A: Frank, These degree shims are 2.5" wide. Thanks, Don

A: Hello Rickster, Thank you for the question. This shim is aluminum and they will fit your vehicle application.

A: Hello busterkapp, They are 2.5" wide and make out of aluminum. Thank you for the email.

A: Cal I am not showing a set of 6 degree shims that are 1.75 wide from procomp but I do have a set from skyjacker. http://jo.my/uu637f

A: Cal you would want the 4 degree wedges. They can be found here. http://www.4wd.com/Jeep-Lift-Kits-Jeep-Lift-Kits-Suspension/Degree-Shim.aspx?t_c=1&t_s=101&t_pt=8731&t_pn=EXP99-400B