Grab A Gear Into Spring & Save Up To 20% | Shop Now
Grab A Gear Into Spring & Save Up To 20% | Shop Now
These NEW Boxed Lower Control Arms increase weld area around the bushing eyelet for improved strength. There are now specific front and rear arms that can be mounted traditionally with the bend down or upside down for improved break-over angles. The front arms are formed to eliminate tire scrub at steering lock.
I bent my control arm and needed to replace it with something that was obviously stronger than a stamped metal plate for a control arm like the stock. These looked about as tough as you could get and great for sliding over when contact was made. These are a bit heavy but if your looking for something tough, it only makes sense. These are the way to go. Only negative I can think of is that they are not adjustable. But if your running stock length. I couldn't imagine better.
Q: Will these work on a stock height 93 XJ? Answer this question
A: No, the 55200 was designed to work on 1.5-3.5” lifts.
Answered by Christian from 4WP HQ on 02/23/2021
Q: 99 TJ wrangler with 4-6 inches of lift. I was reading the questions that asked what the max lift was for these arms and one answer stated they are designed for 3.5 in and the other said they are designed for 4-6 in lifts. Which is it? Answer this question
A: Justin, The max lift the Pro Comp Suspension Boxed Front Lower Control Arms will work with is 4".
Answered by Leon on 08/12/2014
Q: What is the highest lift height these control arms are designed to work for? Answer this question
A: Hello Scott, the Pro Comp Suspension Boxed Front Lower Control Arms part# EXP55200 are designed to work with 4-6" suspension kits. Thank you for your inquiry.
Answered by mikey on 07/17/2014
Q: I have a problem with tires rubbing lower control arm , tire size is 35/12/50s with a 4 inch suspension lift , will this work with my application ? Answer this question
A: Hello Michael, Thank you for the question. This may help, however it sounds like you have the incorrect wheel backspace. The size tire requires a 3.5" to 4.5" wheek backspace.
Answered by RK on 06/13/2014
Q: These look awesome. I have a 4" lift on my '03 TJ. will they work? if not, is there another set that will? Answer this question
A: Hello Daniel, Thank you for the question. Yes, the Pro Comp Suspension Boxed Front Lower Control Arms Part Number: EXP55200 will fit your vehicle application.
Answered by RK on 05/23/2014
Pro Comp Suspension has spent the last two-and-a-half decades engineering, testing and manufacturing products that will give Jeep drivers the confidence to dominate whatever terrain is ahead. The Pro Comp Promise Life Time Warranty is forever. Pro Comp's warranty goes with the suspension products on Jeeps whether or not the Jeep owner is the person who originally purchased the product. Pro Comp Suspension can afford to give such a warranty because the products are produced at the Pro Comp facility in San Diego, California under exacting manufacturing standards. Pro Comp Suspension is the only suspension company with products that are tested under true driving conditions on outside roads, rather than simulated testing. Shop Pro Comp Suspension Now