Pro Comp 2.5 Inch Lift Kit with ES3000 Shocks - K3063 | 4wheelparts.com

Pro Comp 2.5 Inch Lift Kit with ES3000 Shocks - K3063

Specifications

  • Pro Comp Suspension | Part Number: EXPK3063
  • Lift kit:2.5 Inches stage 1
  • Rear Shocks:ES3000
  • Rear Lift Component:Leaf Springs
  • Front Shocks:ES3000
  • Position:Rear
  • Fitment:Direct Fit

PRODUCT OVERVIEW

Pro Comp is driven by genuine off road enthusiasts. Pro Comp Suspension Products reflect customer-driven, racing influenced technology and engineering with a focus on world-class manufacturing processes and techniques. When it comes to your vehicles handling, look and performance, we know you don't make compromises and either do we. From the middle of downtown to the middle of nowhere Pro Comp will get you there and back.

Customer Reviews

4.3
4.3 4.3
3 Customer ratings
4.0 Easy Install

The Directions were weak but I've done this before so the instll went quickly. They are not too clear when you should use the supplied shims, or the direction in which they should be placed. 4 stars only for just that reason.


from South Bay Ca. |
 
4.0 Lift kit as advertised.

Lift kit fit well. Ride is a little stiffer than stock as expected. 4 wheel parts did an excellent job on delivery and even shipped me a replacement bushing that was lost in shipment quickly. Instructions on lift kit were a little sparse. I guess the figure jeep owners know all. Could use drawings.


from Colorado. |
 

Similar

Question & Answers

5 Answered questions

Q: Do I need to replace the shackles or do I use the existing one. Answer this question

A: Hell Ghia, You will use your existing shackles to install this kit. Thank you for the question.

Answered by RK on 07/18/2015

Q: I have a 83cj 5 i ordered a 2.5 in. leaf spring lift from procomp. The springs look the same but after putting them on the front if lower then the rear. Is there a difference between the front and rear springs or did i get the wrong springs.front spring has the numder 36695 on them and the rear has the number 51222 Answer this question

A: Hello chris and thank you for your question! Pro Comp Suspension 2.5 Inch Lift Kit with ES3000 Shocks has the front leaf springs of EXP51212 and the rear leaf springs of EXP51222.

Answered by Nick on 12/17/2014

Q: I have an '85 CJ7 with stock suspension. I want a little ground clearance, 2-2.5" and a softer, smooth ride, tired of putting on suspensions that jar your teeth. Will this one do that or is there another kit your recommend? Answer this question

A: Carl- Thanks for the question. The Pro Comp Suspension 2.5 Inch Lift Kit with ES3000 Shocks will give you a close to original stock ride. It will be a little stiff until the springs settle in. Any all spring kits or add a leaf kits will ride more firmly than stock height due to the arch of the spring.

Answered by Mike on 05/19/2014

Q: I purchased this kit sometime ago and I am finally getting back into putting my 86 CJ7 back together. I put the lift on prior but I am looking to take it back off to clean the frame up yet again. My question is about the spacers and where they need to go (not even sure if I still have these or if they were installed in the first place)? do these go between the rear axle and the spring to allow the axle to rotate slightly for better alignment of the drive shaft. Any information you can provide would be helpful as the directions are lost as well. Answer this question

A: Rich- Thank you for your question. The shims in the Pro Comp Suspension 2.5 Inch Lift Kit with ES3000 Shocks go between the axle and the spring to adjust your pinion angle.

Answered by Mike on 04/05/2014

Q: Will I need anything else for the installationsuch as transfer case lowering kit or drive shaft mods? Answer this question

A: Rick a 2.5" lift kit will not require additional modifications be made to your vehicle of curse with the age of your vehicle other worn parts may start to present them selves like driveshaft vibrations thank you

Answered by steve on 10/14/2013

Manufacturer

Pro Comp Suspension has spent the last two-and-a-half decades engineering, testing and manufacturing products that will give Jeep drivers the confidence to dominate whatever terrain is ahead. The Pro Comp Promise Life Time Warranty is forever. Pro Comp's warranty goes with the suspension products on Jeeps whether or not the Jeep owner is the person who originally purchased the product. Pro Comp Suspension can afford to give such a warranty because the products are produced at the Pro Comp facility in San Diego, California under exacting manufacturing standards. Pro Comp Suspension is the only suspension company with products that are tested under true driving conditions on outside roads, rather than simulated testing. Shop Pro Comp Suspension Now

This Product Fits the Following:

  • 1986 Jeep CJ7 Base  
  • 1986 Jeep CJ7 Laredo  
  • 1986 Jeep CJ7 Renegade  
  • 1985 Jeep CJ7 Base  
  • 1985 Jeep CJ7 Laredo  
  • 1985 Jeep CJ7 Renegade  
  • 1985 Jeep Scrambler Base  
  • 1985 Jeep Scrambler Laredo  
  • 1985 Jeep Scrambler Renegade  
  • 1984 Jeep CJ7 Base  
  • 1984 Jeep CJ7 Renegade  
  • 1984 Jeep Scrambler Base  
  • 1984 Jeep Scrambler SR  
  • 1983 Jeep CJ5 Base  
  • 1983 Jeep CJ5 Laredo  
  • 1983 Jeep CJ5 Limited  
  • 1983 Jeep CJ5 Renegade  
  • 1983 Jeep CJ7 Base  
  • 1983 Jeep CJ7 Laredo  
  • 1983 Jeep CJ7 Limited  
  • 1983 Jeep CJ7 Renegade  
  • 1983 Jeep Scrambler Base  
  • 1983 Jeep Scrambler SL  
  • 1983 Jeep Scrambler SR  
  • 1982 Jeep CJ5 Base  
  • 1982 Jeep CJ5 Laredo  
  • 1982 Jeep CJ5 Limited  
  • 1982 Jeep CJ5 Renegade  
  • 1982 Jeep CJ7 Base  
  • 1982 Jeep CJ7 Laredo  
  • 1982 Jeep CJ7 Limited  
  • 1982 Jeep CJ7 Renegade  
  • 1982 Jeep Scrambler Base  
  • 1982 Jeep Scrambler SL  
  • 1982 Jeep Scrambler SR  
  • 1981 Jeep Scrambler Base  

Promotions