The JK Rear License Plate Delete Cover snaps into the hole left behind when deleting the stock JK rear license plate mount. This could be useful for those running a Poison Spyder Tramp Stamp or aftermarket rear bumper that relocates the license plate. It is not needed if using Poison Spyder Crusher Corners, as they will cover the hole. Made of black, textured, molded plastic.
Purchased the delete cover to go along with a tire delete cover after breaking the stock plate holder while out wheelin. Definitely a little overpriced for some simple ABS plastic; however the fit was perfect, installation took a firm hand hammer hit in the middle, it popped in flawlessly. Definitely do not want to get it offset on installation or it will probably break the retaining tabs off the back, hand hammer is key.
from Vancouver Island
First one I bought was at the store. Walked outside and tried to install it. Broke the center tab within 5 seconds. Walked back inside to exchange. None in stock. Shipped me a new one. Went to install new one and it broke as well. Most definetly not worth $13. It should be a $3 item. So far tried to install 2 and they both broke in the same place.
Poison Spyder Customs has a heritage in hardcore off-road accessories that started when founder Larry McRae was little. McrRae's daddy use to load him up in the Ford Bronco to explore the off-road trails of the southwest. McRae became a professional rock crawler who raced for Nelson & Nelson Racing in the early 2000s. McRae purchased PSC from the Slay family and kept the vision of developing and fabricating high end quality off-road accessories right in the Pomona, California headquarters . McCrae and his wife are members of the Inland Empire 4 Wheel Drive club. McCrae himself is a Past President and Mrs. McCrae is a past Treasurer. Every product produced by PSC starts as a prototype tested on real trails by members of the club. Shop Poison Spyder Customs Now