Poison Spyder Dana 30 Bombshell Differential Cover - 42-11-030 | 4wheelparts.com

Poison Spyder Dana 30 Bombshell Differential Cover - 42-11-030

universal fit logo

Specifications

  • Poison Spyder Customs | Part Number: PSC42-11-030
  • Popular Axle Manufacture:Dana
  • Type Of Material:Steel
  • Axle Location:Front
  • Axle Type:Dana 30 Standard
  • Fitment:Universal Fit
  • Finish Type:Natural
  • Oil Capacity:Extra Capacity

PRODUCT OVERVIEW

Poison Spyder Bombshell Diff Covers are designed to protect your gears, lockers and diff cover bolts from the most punishing rocks and trail hazards. The stock covers your Jeep came with are weak, stamped sheet metal. Even a moderate tap with a rock can cave it in against your ring gear, causing potential damage to the gears, locker and carrier bearings, not to mention a difficult, messy trail fix. Even more common, though less catastrophic, is "peel back" that can occur when sliding over a rock causes the lip of the cover to peel up, allowing your gear oil to drain causing a hazard for both your Jeep and the environment. The Bombshell Diff Cover is your best insurance against each of these hazards. The Bombshell differential cover is cast from highly ductile nodular iron the same material drag racing differential housings are cast from to handle thousands of horsepower. The design of the Bombshell incorporates recesses to protect the diff cover bolt heads from trail damage, while the profile of the Bombshell acts as a ramp to help slide your Jeep up and over the most troublesome pumpkin-eaters. The ramp profile also results in an extremely thick & up to 1" thick cross-section around the bolt ring, where contact with the rocks is most likely. Throughout the rest of its cross-section the Bombshell is the thickest cast differential cover on the market, from 7/16" to a brutal 1/2" thick at the outermost surface.

Customer Reviews

4.3
4.3 4.3
3 Customer ratings

Customer Images

5.0 Beast of a cover

Beast of a cover. Painted and made the spider red. Gets lots of thumbs up!


from Washington State |
 
null
5.0 Tough diff covers!

Have these poison spider covers on a few different axles now (d60, d44, d30) and they are great! They look trick and are very strong- literally almost a half inch thick nodular iron! They also have a pretty low profile for clearing beefy steering component. Had always fabbed 3/8" steel covers in the past, but after seeing one of these covers in person I decided for the price I would start buying these and using my time to fab other things haha.


from Florida |
 

Similar

Question & Answers

0 Answered question

Manufacturer

Poison Spyder Customs has a heritage in hardcore off-road accessories that started when founder Larry McRae was little. McrRae's daddy use to load him up in the Ford Bronco to explore the off-road trails of the southwest. McRae became a professional rock crawler who raced for Nelson & Nelson Racing in the early 2000s. McRae purchased PSC from the Slay family and kept the vision of developing and fabricating high end quality off-road accessories right in the Pomona, California headquarters . McCrae and his wife are members of the Inland Empire 4 Wheel Drive club. McCrae himself is a Past President and Mrs. McCrae is a past Treasurer. Every product produced by PSC starts as a prototype tested on real trails by members of the club. Shop Poison Spyder Customs Now

Promotions