Poison Spyder Customs BFH front bumper is designed for those hardcore four-wheelers who value strength, simplicity and function. This bumper was literally "Built For the Hammers" with the best ground clearance, tire clearance and approach angle possible. It is no wider than the Jeeps frame rails, with angled facets to improve its ability to slide over the rocks. The BFH bumper is CNC laser-cut from a single piece of high strength 3/16" plate steel, then precision brake-formed for an exact fit. The BFH bumper features an integrated winch mount and one-piece design. The Brawler Bar is a lower-profile Stinger, fashioned after the 2-bend Stinger featured on our Original RockBrawler bumper. The Brawler Bar features the most versatile combination of trail protection and a lower profile for easier access to the engine compartment, fitment into garages and trailers, etc. Plus it looks great! The Brawler Bar extends 7.4" forward from the front edge of the bumper, and 9.8" high from the top surface of the bumper. The Recovery Shackle Tabs are machined from 1" thick plate steel to provide a secure attachment point for 3/4" recovery shackles. These tabs are specifically engineered to match the angles of the BFH bumper to result in zero loss in approach angle.
Poison Spyder Customs has a heritage in hardcore off-road accessories that started when founder Larry McRae was little. McrRae's daddy use to load him up in the Ford Bronco to explore the off-road trails of the southwest. McRae became a professional rock crawler who raced for Nelson & Nelson Racing in the early 2000s. McRae purchased PSC from the Slay family and kept the vision of developing and fabricating high end quality off-road accessories right in the Pomona, California headquarters . McCrae and his wife are members of the Inland Empire 4 Wheel Drive club. McCrae himself is a Past President and Mrs. McCrae is a past Treasurer. Every product produced by PSC starts as a prototype tested on real trails by members of the club. Shop Poison Spyder Customs Now