A: The Part Number: MG22135 - Axle Length 29.25 L (Inch), 29.75 R (Inch) these axle fit: 1997 – 2006 Jeep TJ | 1987 – 1995 Jeep Wrangler | 1997 – 2006 Jeep Wrangler.

A: Hi Samwell From what I checked and your carrier is 30 spline the Dana 35 Non C-Clip Rear Axle Kit is the same length needed. Thanks

A: Hi Jake No the seals and bearings are bnot installed on the Dana 44 Rear Axle Kit as you have to put the brake backing plates on the axles before they are installed. Thanks

A: Hi Jordan, This Ten factory Dana 44 Rear Axle Kit comes with a 10-year warranty from the manufacturer. Thanks for a great question.

A: Hello AJ The MIDMG22135 axle kit comes with the axles, bearings, bearing retaining collars, seals and studs. Press work is required. You will need your brake backing plates from your stock set up to be removed and installed on the axles before the press work is begun. Thank You for your question. Jon Snyder 4Wheelparts

A: Hello Yes Ten Factory says they will accept the tone rings on any of the Dana 35 Jeep axles. Thanks

A: MSchneid, the Ten Factory Dana 44 Rear Axle Kit may not work with your Jeep if it is stock as it could have a Dana 35 rear axle. If you do have a Dana 44, it should be 30 spline since you haven't upgraded it. I hope this helps!

A: Hello Alex, Yes these shafts will work with that setup. They will bolt up just fine. If you have anymore questions feel free to ask, Thank you.

A: Yes the MIDMG22135 axle kit will fit your 2005 Jeep TJ Rubicon