G2 Performance Ring & Pinion sets are engineered with todays most demanding applications in mind. Designed to hold up to oversized tires and high performance engines, these gears use use the latest technology and materials in their manufacturing to give you the strongest and quietest performance gear sets available.
Mr. Sings-like-a-canary probably needs to check pre-load on the pinion shaft, spacing & gear-lash(w/shim kit), and or fluid(s) for starters. Recommend using a Master Install kit w/instructions, and using ALL required torque wrenches and gauges.
By Sierrafox 13
from Logan, UT
5.0Great Price! Nice and Quiet!
I was concerned that a few reviews indicated that their R&P's were noisy. I have found just the opposite. Install went smooth, and after about 5000 miles, almost all of it towing a 2700lb trailer, it's still quiet and tight. 75% less cost than a factory replacement, and seemed heavier than the original that came out.
from Finger Lakes, NY
5.0Great set of gears
I installed these in my 94 1500 and noticed a big difference in the off idle power. I went from the stock 3:55's to a set of these and the engine no longer shifts all over the place while driving around town or going up a hill. Fuel mileage is about the same. I'll be using G2's in the future again. Don't forget if you change your ratio from the stock setup it'll throw off your speedometer....
By Big Blue Ram
from OKC, OK
5.0Good product, no run out, good pattern
Good kit shimed up well and gave good tooth contact and pattern
4.0does its job
before buying this product i did alot of research. I went with these gears because they said it is as queit as stock gears...bottom line there arent, they arent loud but you can hear a slite whine...would buy again though, truck pulls hard of the line, not worried about breaking teeth on gears
from ft lewis, wa
5.0Great product quality. Very happy....
These were very good quality replacement parts. I am very satisfied. Thanks...
By J.R.'s Service
from Wray, Colorado
4.0Upgrade time !
Needed an upgrade from my stock 3.55 to 4.10's as they were beginning to wear.
from Chula Vista, CA
1.0Great performance, but really loud
I went from the the factory 3.55 in my 2009 Dodge RAM 1500 to G2's 4.10. The difference in performance is like night and day. Finally the truck feels like it's got the 390+ horse power Dodge claims. It was an added bonus that based on my driving style, I actually saw a +1 MPG increase! The horrible part is that these gears have a very, very high pitched whine. Even with a Flowmaster Super 40 on the truck, the rear end will drown out the exhaust and even the radio when it's only turned on low. If you've got a newer truck with a quiet cab, skip these and go with OEM gears or you'll be regretting it. [...]
G2 Axle & Gear uses the strongest and latest generation materials to manufacture products capable of handling heavy loads. When it comes to axle assemblies, core lockers, driveshafts and sway bars, G2 is the first name in durability and reliability. Off-roading can heap punishment on a Jeep and G2's laser-cut components offer superior handling on challenging terrain and on-road drives. Parts are easy to install and easy to service and above all, they remain operational in adverse environments. Shop G2 Axle and Gear Now