The FOX Performance Series Adjustable Through Shaft (ATS) steering stabilizer offers unrivaled steering control and a striking high tech appearance. The technologically advanced design cancels unwanted steering forces in both directions, taking the place of two conventional opposing stabilizers. It will also respond to your input with 24 clicks of external adjustment to fine tune the feel. The integrated reservoir allows for additional fluid capacity and improves cooling during extreme use. Also included is FOXs relocating hardware that moves the steering stabilizer up and out of the way utilizing a new track bar relocation bolt and tie-rod mounting clamp. The ATS represents a revolutionary breakthrough in stabilizer design.
The vehicle was a 2012 Rubicon with a 3.5" AEV Lift and 35" Procomp tires. There was a good amount of bump steer going on. After installation this was corrected. I believe I set the valving at 7 clicks out from maximum. The photos in the instructions are very poor and even being an expert mechanic the only way to figure out proper installation was to see "how it could fit". Clearly the instructions are based on someone who already knows how to install it vs could a gradeschooler understand this. Also it is impossible to remove the stock stabilizer mount on the tie rod without a torch to heat and open it up enough to clear the body of the tie rod because the mount is factory slid on before the tie rod ends are screwed on.
Can you install this stabilizer on stock 2010 Jeep Wrangler Sport that does not have a lift kit? Seems from installation instructions you can. Is it necessary or recommended to add optional 1 5/8" tie rod assembly?
What about Fox Shocks,#'s 985-24-027 and985-24-208. Can they just bolt on to existing brackets?
Last do you have a installation location near my zip code (07405)?
Joe from Kinnelon, NJ on
Yes, the Fox Racing Shox 2.0 Performance Series ATS Stabilizer FOX983-02-070 will fit the stock height vehicles. Part Number: FOX985-24-027 will fit the front and Part Number: FOX985-24-028 will fit the rear of your vehicle. They are all a direct bolt-on installation. Thank you.
from Kinnelon, NJ on
i have the rock krawler tie rod for my jk and the fox 2.0 ats stabilizer and the bracket does not fit the bar what do you recommend i do the bar dia is much larger
pete from brandon on
Hello pete and thank you for your question! We would need to contact Fox Racing Shox to get the correct brackets for Fox Racing Shox 2.0 Performance Series ATS Stabilizer.
Nick from brandon on
Ask a Question About This Product
Please Review Your Submission
Thank you for submitting your question.
We will process your question within 24 hours.If you need immediate assistance,
please call 855-229-4637.
Bob Fox, founder of Fox Racing Shox, had a dream in 1957. That was to create a better shock absorber for dirtbike racing. From that dream Bob Fox built and grew Fox Racing Shox. Now Fox Racing Shox creates the type of performance shock absorbers that lead the Fox team to victory in the 2015 UTV World Championships and lead to the FOX Athletes dominating in the 2016 Mint 400. Fox has over four decades of experience manufacturing shocks that are meant to win in a variety of motorsports. Fox engineers take what they learn from dirtbike, mountain biking and drag racing and apply that technical knowledge to the development of off-road shocks. So Fox innovation and product support is top of the line. Shop Fox Racing Shox Now