Fabtech Coil Springs

hi, I was wanting to know if I bought these 6 inch spacers,i guess they wont work with the stock front shocks correct? if not what part number do I need or do you recommend that I use with them?thank u very much and whats the cost of the struts I should use?

Asked by charc from mcclave, colorado on

Thanks for the inquiry charc, the Fabtech Coil Spring Spacer Kit part # FABFTS26010BK utilize a factory strut in thei 6 inch suspension. see here http://jo.my/xbgnge

Answered by from mcclave, colorado on

so i have a 2001 ford ranger with 3in body lift would they fit

Asked by Josh from roxboro nc on

Hi Josh, The FABFTS98100-2 will fit a Ranger 2WD with a 4cylinder or the 3.0L V6. The FTSFTS98100-3 will fit a Ranger 2WD with a 4.0L V6. The 2.5 inch coil spring lift must be used with the Fabtech Upper A-Arm Kit part number FABFTS98100-6BJ. Also 2 each of FABFTS7119 front shocks which are longer than stock. Alignment Cam Kit part number FABFTS291 would complete the parts need for the front. In the rear of the Ranger you could lift it with an add-a-leaf kit or with rear blocks and longer ubolts. The add-a-leaf kit would add more spring rate for carring extra weight the block/ubolt rear lift would raise the rear but would not be firmer. The add-a-leaf kit is FABFTS202 and the blocks are FABFTSBK2 and the ubolt kit is FABFTS725. You will need 2 each of FABFTS7265 longer than stock rear shocks This is an excellent suspension lift and I highly recommend it. I hope this was helpful. Thank You Jon Snyder 4Wheelparts

Answered by from roxboro nc on

I have an 02 toyota tacoma 4x4 with a 6 inch fabtech lift on it and need to replace the struts, but the cost of custom srtuts is to expensive. Would this fit for using with stock struts.

Asked by josh from milford pa. on

Thanks for the inquiry josh, the Fabtech Coil Spring Spacer Kit part # FABFTS26010BK this will not work you'll need new extended struts part # FABFTS70001S sold each.

Answered by from milford pa. on