Dana Spicer Spindle Nut Kits

A: This fits Dana 30, Dana 44 and GM 8.5 axles. If you have a Dana 44 axle, this will fit. Includes outer nut, inner nut with pin and washer.

A: Hello Ed, Yes, this will fit the 3/4 ton Dana 44 axle. Thank you.

A: Hello The front axle would of used the hex style nut not the 4 slot style. Some of the conversion kits did use the Dana 44 style like this kit. You adjust the pre-load on the bearings with the inner nut with the pin in it. then install the washer with holes to line up with the pin. Next install the out nut against the washer and tighten to 60-70 foot pounds. The inner nut can't move since the washer is keyed to the spindle and to the pin in the nut. The original style nut kit would be link the one in this link. http://www.4wheelparts.com/Drivetrain-Differentials/Dana25-27-30-Spindle-Washer-and-Nut-Kit.aspx?t_c=12&t_s=514&t_pt=8318&t_pn=CROA867K Thanks Rody

A: Hi Khris Our Las Vegas store does have them in stock but i have no way of knowing it they are available for sale or on hold for a customer. these are usually a stocking part. Thank You

A: Hi ThreeJeeps At this time i am showing two kits in stock in the Santa Ana store Thank You

A: Hello Myron, This part number only fits the DANA 30, 44 and GM 10 Bolt axle. You need a par t number D/S660568. This fits a DANA 50 and 60. Thanks for the email.