Dana Spicer Dana Spindle Nut Kit - 28068X

universal fit logo


  • Dana Spicer | Part Number: D/S28068X
  • Fitment:Universal Fit


Looking for a single spindle nut of a complete set Dana Spicer has spindle nuts for most popular applications.


Perfect Fit

Outer bearing went out and wrecked the original outer nut... had to do some filing and rethreading... these nuts were hard enough to go on over the bad threads and worked perfect.

from North Dakota |
Dana Spindle Nut Kit

got me bout 2 hunnert miles on it and its still holdin stong! what can i say its a locknut GREAT PRODUCT! Threw it on the Dana 44 under my weekend wheeler Chevy k20.

from Battle Ground, WA |
spindle nut kit

Great for switching from auto hubs to manual

from Savanna il |
I would buy products again

very easy installation

from Ligonier, Pa |
dana spindle nut kit

I put these on my 96 ranger 4x4 to install manual hubs in place of the over priced kit that warn offers these parts are stronger and cheaper.

from mid-western, il |
Good fit

Installed without a problem.

from The Dalles, OR |
Only place in town...

This product fit perfectly and I have had no issues with it.

from Florida |

Question & Answers

5 Answered questions

1988 Chevy 3/4 Ton 4x4. Will this kit fit?

Asked by Ed from Tn on

Hello Ed, Yes, this will fit the 3/4 ton Dana 44 axle. Thank you.

Answered by from Tn on

What keeps the outer nut from backing off? Is it just tightened so much that the nuts and washer jam together? What is the torque on the outer nut if this is the case? This is on a 74 CJ5. D30 on the front, D44 on the rear. Both have Warn lock outs.

Asked by new jeeper from on

Hello The front axle would of used the hex style nut not the 4 slot style. Some of the conversion kits did use the Dana 44 style like this kit. You adjust the pre-load on the bearings with the inner nut with the pin in it. then install the washer with holes to line up with the pin. Next install the out nut against the washer and tighten to 60-70 foot pounds. The inner nut can't move since the washer is keyed to the spindle and to the pin in the nut. The original style nut kit would be link the one in this link. http://www.4wheelparts.com/Drivetrain-Differentials/Dana25-27-30-Spindle-Washer-and-Nut-Kit.aspx?t_c=12&t_s=514&t_pt=8318&t_pn=CROA867K Thanks Rody

Answered by Rody from on

Do you show any inventory at your las vegas location for this part?

Asked by khris from vegas on

Hi Khris Our Las Vegas store does have them in stock but i have no way of knowing it they are available for sale or on hold for a customer. these are usually a stocking part. Thank You

Answered by Stevie from vegas on

See all questions & answers


Dana Spicer products strive to meet the same high standards as OE parts, but in reality they are OE parts. The company's commitment to engineering and design innovation stretches back to 1904 when Dana was founded and began producing Spicer products. That legacy translates to quality, dependable axle components that keep Jeeps out on the trail and help daily drivers brave commutes with confidence. Driveshaft parts, universal joints, Dana axles and Spicer axle components are some of the Dana Spicer products that Jeep owners know they can count on. When you need to tighten up a sloppy differential, replace the clutches in your limited slip or replace a worn out yoke, call on Dana Spicer. Shop Dana Spicer Now