A: Hello You need the yoke for the rear GM 10 bolt it would be part number PTI 3R04-02 they run 64.99 I don't think they will show up on the website you can call in to order. Thanks

A: Thanks for the question. Sorry,but this will not work for your application. You will want to order this part # JER2-4-3124R Thank you.

A: Thanks for the question. D/S2-4-8091x This will not work for your vehicle. You will want to order the PTI3304-261. Thank you

A: Hello Yes this is the correct yoke for your Dana 44 axle. The U-joint would be part number D/S 5-153X yoke u-bolts are part number D/S 2-94-28X and the seal is part number D/S 44895 All of the items are in stock.

A: Hello Yes this yoke will work with your Dana 35 front end. The new pinion seal is part number D/S 40554 If you need the u-bolts they are part number D/S 2-94-28x

A: Hello No special seal needed on the Dana 44. The special seal is for the Dana 35 only.

A: Hello Alex Yes that yoke will work if you want the u-bolt style yoke. You would also need the u-bolts d/s 2-94-28x and pinion seal d/s 40554. If you want the stock strap style it would be part number d/s 2-4-4601-1

A: Hello Moses All of the master kits come with the pinion seal for the yoke. If you end up not needing the complete kit the seal number is D/S 44895.

A: Hello Bill To go to the u-bolt style yoke it does need the National seal. We have the yoke in kit form with the seal, yoke, and u-bolts. The part number is Kit 35k but it won't come up on the website. You would have to call the order in or visit the local store.

A: Hi Ryan This yoke will fit the Dana 44 Axle in your 1994 Dodge, Just make sure that your driveshaft is an Dana Spicer series u joint and not the Detroit style. The Dana will have little tangs that center the joint in the yoke and the Detroit uses snap rings on the joint caps. Thank You

A: Hi Michael Your Dodge may be using the Detroit 7260 or Detroit 7290 series U-Joint. the Detroit series U-Joints have snap rings on the inside of the of the yokes to retain the U-Joint cups. The Dana series U-Joints use snap rings on the outside of the U-Joints in the drive shaft and a small little tang in the yoke were the Joint sits. The location of the yoke is also important are you looking for a front or rear axle or transfer case yoke what axles and transfer case do you have? Thank You

A: Hello jeeplift, Thank you for the question. No, this only fits the Dana 30, 35 and 44 axles.

A: Tommy- Thank you for your question. The Dana Spicer Dana 30/35/44 1310 Series Pinion Yoke should fit your 92 ford Ranger 4x4. You might also need the u bolt kit found here http://jo.my/3bgzo