These Dana Spicer Flange Yokes adapt your standard style drive shaft to a flat Companion Flange style yoke. Jeep enthusiasts everywhere trust genuine Spicer parts for unparalleled performance in even the toughest conditions. The new genuine Spicer driveshaft, built specifically for the Jeep Wrangler JK, gives drivers an added edge when going off-road.
With work for the back of a dana 18 on a flange parking brake for the drive shaft
Im old Greg from mass on
The correct yoke for your D 18 transfer care is CRO 116714 it is on our website.
Rody from mass on
I have a 1976 k5 Blazer with a NP 203 will it work for my truck?
Saul from El Paso, TX on
Are you looking for a flange yoke for the front drive shaft at the transfer case? This unit would bolt onto the stock flat flange.
Rody from El Paso, TX on
Will this work on a 2009 Toyota Tacoma 4x4 v6 ext cab
Dawn from La. on
The Toyota has a unique bolt pattern that this flange will not fit. you could modify your Toyota flange yoke to fit this but it really needs to be done by a competent machinist. A company called Neapco does make a 1310 Flange yoke to adapt the 1310 joint to the Toyota but we do not carry them. Thank You
Dana Spicer products strive to meet the same high standards as OE parts, but in reality they are OE parts. The company's commitment to engineering and design innovation stretches back to 1904 when Dana was founded and began producing Spicer products. That legacy translates to quality, dependable axle components that keep Jeeps out on the trail and help daily drivers brave commutes with confidence. Driveshaft parts, universal joints, Dana axles and Spicer axle components are some of the Dana Spicer products that Jeep owners know they can count on. When you need to tighten up a sloppy differential, replace the clutches in your limited slip or replace a worn out yoke, call on Dana Spicer. Shop Dana Spicer Now