Crown Automotive Steering Tie Rod Assemblies

A: Hello, The Crown Automotive Tie Rod Assembly does go from knuckle to knuckle and are greasable. Please let us know if you have any other questions. Thanks!

A: Richard, The Crown Automotive Tie Rod Assembly has sealed tie rod ends and are not greasable. Please let us know if you have any other questions. Thanks!

A: Hi Lou The Tie Rod Assembly has a 43 3/4 inch tube. Thanks

A: Hi Lou The length of the tube on the Tie Rod Assembly is 40 1/2 inch. Thanks

A: Hi Antonio Yes the Tie Rod Assembly is everything in the picture, it is from knuckle to knuckle. Thanks

A: Hey Dickie, these tie rod ends do have grease fittings. I hope this answer and earns your business. Thanks for your question.

A: Moparnjeep- Thanks for the question. The Crown Automotive Tie Rod Assembly is the section from the driver side knuckle to the drag link. The ZJ Grand cherokee is set up with an inverted Y design. This means the steering goes drag link from the pitman to the passenger knuckle, interrupted in the middle by the Tie rod that goes from the passenger side of the drag link to the driver side knuckle.

A: Hi Moparnjeep This is a complete tie rod assembly from knuckle to knuckle and does not include a draglink. Thank You

A: Mike- Thanks for asking. The Crown Automotive Tie Rod Assembly is a exact factory replacement so it does not have grease fittings on the tie rod ends.

A: Ed are you talking about reusing your factory long tube and just replacing the tie rod assembly? If so I do not see any problem doing that (If it ain't broke don't fix it) I would still suggest you get an alignment done after you install.