Body Armor 4X4 Sheet Metal Design Front Bumpers

I've had the bumper on for about 6 months now and it's still as FRESH as it was when it was first installed. It's a good, solid bumper and luckily when I got it - it was on a 4wp sale! Now I'm looking to adding lights and a winch, I would highly recommend to get the skid plate (sold separately) just to make it look even better!

Bumper is heavy. Installation instructions are horrible. The front passenger mounting holes were off - they did not line up with the passenger side mounting bracket on 2014 Jeep Wrangler and bottom mounting holes were so close to the weld that the bumper could not be modified; had to grind off 1/4 inch of mounting bracket on the jeep. For installing the side bolts, do NOT drill into the Jeep mounting bracket until after you have installed the front mounting bolts, otherwise you'll be putting multiple holes in the frame. Use the existing side hole on the bumper as a guide of where to drill the hole in the frame.

Very solid and good looking bumper with winch mount. Difficult to install. Excessive weld would not allow for precise fitment. Had to alter the frame mounting points by grinding and drilling the four hole plates. Side attachment bolts did not line up. Had to drill new holes.

Everything has been great in the 2 weeks I've had this bumper on! Only gripe I had was during installation discovered that the bolts that come with the bumper are too short and there is absolutely no way to get both the regular AND lock washer on there. Opted to just go with the lock washers. Hopefully it doesn't fall off anytime soon!

realy should have had instructions, grill bar should have the mounting nuts welded into bumper. be sure to attatch bar prior to mounting or enjoy doing it twice. drill out bumper mount holes in frame,of jeep to ease allighnment.realy good construction as I use my winch a lot

even following directions bolt holes not even close to lining up.dont buy this bumper unless you have alot of extra time

THE BUMPER WAS EASY TO INSTALL.I USED A ATV JACK TO LINE UP.THE SIMPLE WAY TO INSTALL THIS BUMPER BY YOURSELF.THE ONLY PROBLEM I ENCOUNTER WAS THE BOLTS WERE A LITTLE TO SHORT,SO I INSTALL ALL THE BOLTS WITHOUT THE WASHERS AND SNUG ALL THE BOLTS UP, THEN WENT BACK AND REINSTALLED THE WASHERS,THIS WORK PREFECT.I ALSO INSTALLED A X2O WINCH ON THIS BUMPER AND IT LINED RIGHT UP.IT WAS A PREFECT MATCH.NOW MY RUBICON LOOKS LIKE A JEEP.

Install was a breeze, Looks great, light and a lift kit comming up. 4 wheel parts is the only place i shop

[...] It was easy to install and directions were clear. [...] I will always buy from you!

Great bumper looks awsome. bolts were a little short during installation but just didn't use some of the washers. it looks great though and all holes for lighting and winch are predrilled nicely poweder coated.