Alloy USA Differential Master Overhaul Kits

A: Hello JF The ALY380002 Dana 35 Yoke Conversion Kit does come with the u-joint. It is a 1310 series u-joint. Thank You for your question. Jon Snyder 4Wheelparts

A: Hi Jane The Dana 35 Rear Master Installation Kit is for the rear axle center section to set up the ring and pinion, I think you may be thinking the axle bearings. Thanks

A: Hello Yes the crush sleeve goes between the two bearings. It will be placed just below the upper / outer pinion bearing. The new one replaces the old crush sleeve.

A: Hello there, the Rear Master Installation Kit is a ready to install item for your Dana 44 JK Rear. Shop with us anytime, on your schedule. Browse 4WheelParts.com, call our customer service center, or come visit us in one of our stores. You can even save on shipping costs by shopping online and picking your order up in a store. No matter which method you prefer, we’re ready to help with excellent parts, advice, and service.

A: Hello This kit is for the Dana 30 your truck has the Dana 60 in it. We do have the Dana 60 yokes also. The part number you need is Cur 60-1350 and u-bolt kit D/S 3-94-18x

A: Hello Yes that yoke kit will fit the 30 and 44 axles as they both have the same spline. Thanks

A: no I'm sorry that it won't fit you 53 Hudson. You will need to order all separate parts.

A: Hello The kit you got is for the Jeep Grand Cherokee and will not work on you Dodge. Here is the number you will need. G/2 35-2033B I looked at the parts in the kit you ordered and all of the bearings are wrong.

A: Hi Jeeper This yoke will replace the factory rear yoke and allow you to reuse te factory drive shaft or most after market drive shafts. Thank You

A: Hello, the U-bolt nut torque for the 1310 Series Yoke is 14 to 17 Lb. Ft. Thank you!

A: Yes, this is a 26 spline piece. Thanks!

A: This conversion kit comes with the 1310 style U-joint.

A: Hello, This Yoke Conversion Kit fits the 1310 style u-joint. If you need anything else, please don't hestitate to ask. Thank you.