Alloy USA Axle Tube Seals

A: I called Alloy USA and talked to a tech guy there and he did not know. I looked up the inner axle seals on the Dana web site and the Ultimate 44 has it own inner axle seal but they can be used on the standard JK front ends so the Dana Ultimate 44 should have the same axle tube inner diameter even though it has thicker axle tubes than a stock JK front end. So I do believe they will fit into the axle housing. The chromoly axle shafts in the Dana Ultimate 44 have stouter yokes so some clearance of the edges of the yokes may be needed but I think the ALY11105 will fit.

A: Yes this will fit.

A: Hello Yes since the CAD is gone it will work now. Thanks

A: Hello Yes they are for the stock 27 spline axle shafts.

A: Hello They will work as long as you don't have the vacuum disconnect front axle. Thanks

A: Hello Kit No there is no seal for the early Dana 44's. There is no clearance between the axle yoke and the C end for a seal. I have seen guy's put a seal in the axle tube about 3/8th of an inch inside. The problem is no way yo keep it greased so the axle won't burn the seal. Thanks

A: Hello There isn't enough room for the seal with the CV style axle shafts. Thanks

A: Hello Jeffrey These are for the front only and do not replace the stock seals. They are designed to keep dirt and debris out of the tube. This seal doesn't work as a grease seal at all. Thanks

A: Hello Richard These won't work on the early 44's there is no room between the tube and the axle. The yoke of the axle shaft is right up against the c-end on your housing. Thanks

A: Hello Mike, These Alloy USA Dana 30/44 Black Outer Axle Tube Seals will work on any Dana 44 front axle.

A: Hello Tim Yes as long as you install the solid axle they will work fine.

A: Hello Chris. The Alloy USA JK Dana 30/44 Red Outer Axle Tube Seals, part # ALY11105, will fit the 2011 JKU Rubicon with the Dana 44 front axle. Thank you

A: Hello The price is for a pair of seals. Yes they work on your Cherokee.

A: Hi Doc_Rock The alloy USA tube seals as well as others require about 1 1/2" of clear tube with out the Nitro sleeves for them to fit in. I believe that the sleeves extend to the end of the tube so the outer tube seals will not fit. you will need to measure the new inner tube diameter and we can see if anybody makes a set to fit. Thank You

A: Hello jeeper creeper, Thank you for the question. Yes, they are sold as a pair.

A: Hi SnowFlake The outer tube seals will not fit the full size 1988 Jeep Wagoneer (SJ) Dana Axle. There is not enough room for a seal between the end forging and the axle yoke to fit one. Thank You

A: Thank you for the inquiry Willightsm. The Alloy USA Dana 30/44 Red Outer Axle Tube Seals part number ALY11105 are sold as a pair.

A: Hello mars, Yes, the Alloy USA Dana 30/44 Red Outer Axle Tube Seals ALY11102 will fit the 2007 to 2014 Jeep JK Wrangler Rubicon Front Dana 44 axle. "Will Not Work With Passenger Side Vacuum Disconnect Two Piece Axle Shaft" is for the older 1987 to 1990 Jeep YJ Wranglers that came with the vacuum disconnect 2 piece axle shafts. Thank you for the email.