PRODUCT OVERVIEW

The Air Lift 23380 Viair 380C Air Compressor Dual Pack is a bundling of two complete Viair 380C air compressor kits. A pairing primarily designed for use in small to medium dual axle/suspension onboard air compression systems, vehicles utilizing the Viair 380C Air Compressor Dual Pack effectively double the productivity of a single kits compression ability and efficiency, while maintaining a low-draw scenario on their shared onboard 12-volt battery source. This kit is suitable for use with either 2.5 gallon or 5 gallon air tanks.

Higher, Faster Pressure Rates at Low Amp Draw
The increasing popularity of automotive air management systems powered by onboard air compressors has brought predictable benefits to drivers across the automotive spectrum hungry for ever more flexibility when it comes to tuning the suspension within their rides. But with increasingly sophisticated, and common, in-vehicle applications like dual path control allowing for independent suspension of each wheel and the constant want for faster fill rates, increasingly high duty cycles and overall lower amp draw on vehicle 12-volt battery sources, it's not likely that a single compressor can provide all that consumers need. This is where Air Lift's Dual Pack line of Viair compressors comes in.

Air Lift's Viair 380C Air Compressor Dual Pack
The Viair 380C is a true continuous duty, 12-volt, 200 psi compressor. By itself a single Viair 380C is capable of filling a 5-gallon tank from 165 psi to 200 psi in 3½ minutes consistently, while never pulling more than 18 amps of power (@ 13.8 volts). As good as this is, consumers looking for immediate results from their onboard air suspension system, especially for dual path systems, can up this performance even further by opting for an Air Lift Dual Pack system. The Air Lift Viair 380C Air Compressor Dual Pack features 2.98 CFM @ 0 psi. 5 gallon tank fill rates: empty fill (0 to 200-psi) 7 minutes 11 seconds, and recovery rate (165 To 200 psi) 2 minutes 6 seconds. Couple this with 100% duty cycle @ 100 psi, 55% duty cycle @ 200 psi and up to 200 psi of pressure using only 32 amps of power and you have a workhorse that could really put the spring back into any small to medium air onboard air compression system. Additional features include a standard ¼" stainless steel braided leader hose with ¼" NPT inline check valve and insulated wiring.