If you?re looking at building your own front bumper, one of our winch mount plates will make a great starting point. These winch mount plates bolt on in the factory frame holes, and are made from CNC bent 1/4 inch steel plate. We built them with two inch receiver tubing so that you can use a receiver shackle for a pull point or a recovery point. We also predrilled holes for easy winch mounting. If you can bend tube this winch mount plate is all you need to build a great custom bumper. Note: Some winches may require slight trimming or clearancing of the grill.
The mounting plate is made out of 3/8? thick steel with a 1? thick d-ring mount and 1/2? laser cut hardware. This d-ring mount is designed for their 3/4? d-rings. Available in a 3?x3? and 3?x3.5? mounting patterns.
Trail Gear?s Hi-Lift Jack Mount is laser cut from 3/16? thick steel and then CNC formed. The ends of the mount are coped so that they can be welded to 1-3/4 inch tubing. We use a 1/2 inch thick bolt that has a precision hole drilled into it so that a hair-pin/cotter style pin can be inserted. This will keep the nut from rattling off and ensure that you never lose your hi-lift jack on the trail. We also added rubber pads that go between the jack and the mounts and a Velcro strap to hold the handle in place so that no vibration will be heard from any of the mounting locations. A second hole was placed on the mount so that you can put a padlock on the hi-lift to keep it totally secure from loss or theft. Product is shipped unpainted, must be welded on.
Trail Gear's Steering Ram Clevis End Kit is one of the most complete kits on the market. All necessary hardware is included along with the necessary spacers. The Clevis ends are clear zinc-plated for a sharp look and long lasting finish. This kit will fit most large double endedsteering rams and 3/4in. single ended rams. This design works best with Heim-style rod ends with a 3/4in. bolt hole
Synthetic winch line is expensive to replace so it is important to protect your line and make it last as long as possible. We at Trail-Gear understand that, so we developed a stainless steel tube thimble that will protect your line and keep it from twisting and fraying at the ends. Our tube thimble is easy to install. Simply cut your line down a few inches until you have a new clean piece of line, push the line through the thimble and then braid the line so that the thimble is in place.
This Bolt-On Fairlead Mount offers a universal design to fit on most bumpers and will work with a Hawse or roller style fairlead. This fairlead mount has a pre drilled bolt pattern for most 5000-9500 model low-profile winches. Includes 3/8?-16 and M10-1.5 extended winch mount hardware.