We are happy to introduce our new GM Style Alternator Bracket Kit. This bracket kit will allow you to bolt a GM style 1 wire alternator to your 20R, 22R or 22RE motor with no major modifications, and it works with your stock alternator belt. This kit will allow you to say goodbye to the small underpowered OEM Toyota alternator and upgrade to a GM style unit that will supply ample power for your rock lights, stereo, GPS and all the other gadgets that are required for modern day rock crawling and racing.
The TG Battery Box will keep your battery where you want it, even on the toughest rocks and trails. We have all seen the results of batteries not held in place securely, or held in place by bungie cords: fire and sparks. The TG Battery Box can either be welded or bolted into place. It is made out of 1/8 inch thick steel and is shipped unpainted. Once the TG Battery Box has been mounted you simply remove the three bolts and the top lifts off and allows you to remove or install the battery in minutes. The TG Battery Box can either be mounted where your OEM battery was, or, due to its inchflat back inch design, it can be mounted behind your seat or cab. Also present on the TG battery box are 9 mounting holes in the bottom for ease of installation. The TG Battery Box works with Diehard Platinum and Odyssey DT 34/78 size batteries.
Trail-Gear has raised the bar yet again in the Toyota Off Road Industry with the newest addition to our product line, a stainless steel, 50 state legal Toyota header. Our Rock Ripper Toy Header is the best on the market today, it features 100% polished stainless steel 1/16 inch thick tubes going into a 1/2 inch thick header to head mounting flange. We tig welded everything and then polished it to give it a clean look. The Rock Ripper Toy Header is not only made out of the thickest material on the market, but since it is stainless it will not rust or corrode and does not need to be ceramic coat or wrapped. The Rock Ripper Toy Header is plug and play, and all gaskets, connectors, and pipes are included along with full color instructions.
These fittings make great trail spares for the tool box. If a hydro line becomes damaged, simply cut out the bad section of tubing and insert one of these repair fittings into the line. Only for use on low pressure lines and return lines. Not intended for long term use on the high pressure line from the pump to steering box.
Trail Gear's full line of Hose Fittings will help you get the job done right.If you're the type that wants to tap your own box, we have the fitting you need to do it. The fitting has a male 1/4 inch pipe fitting on one end and male #6 JIC fitting on the other end. Two fittings are required for each steering box conversion.
Add an additional layer of filtration and extend the life of your air filter with Trail-Gear's new Rock Ripper Dust Defense Pre-Filter. The TG Rock Ripper?? Dust Defense Pre-Filter is made from high-quality polyester with an elastic cuff to ensure the perfect fit and is designed to run without oil. It extends filter life by preventing large dust particles from entering your air filter, keeping it cleaner longer.
Stock replacement throttle cable for carburetor equipped Samurai's. Includes nuts on carburetor end. Take just a few minutes to install. If you throttle cable is sticking or does not move freely, it may be time for a replacement.
Built out of 3/16 inch Plate Steel, the Trail-Gear Link Mounts are a perfect solution for upgrading the factory brakets. They also make it easy to swap suspension from leaf springs to a 3-Link or 4-Link system.